Rahil Malik (Jan 05 2018 at 10:22): Rahil Malik (Jan 05 2018 at 10:22):How to change my whole model's coordinate to 0 0 0
William Cook (Jan 05 2018 at 10:33):@Rahil Malik Try and follow the following screenshots
William Cook (Jan 05 2018 at 10:35):
William Cook (Jan 05 2018 at 10:35):Try that
Siddharth (Jan 05 2018 at 10:35):Go through the initial lessons of "Introduction to BRL-CAD"
Rahil Malik (Jan 05 2018 at 10:35):I am using mged, can't i change it in there /
William Cook (Jan 05 2018 at 10:36):Sorry, i have no clue
Jeff Sieu (Jan 05 2018 at 10:37):Tbh , idk if this is the proper way, but I do have a method
William Cook (Jan 05 2018 at 10:37):Refer to the tutorial as stated by Siddharth
Jeff Sieu (Jan 05 2018 at 10:37):but its not very precise
Jeff Sieu (Jan 05 2018 at 10:37):you can B the model
Rahil Malik (Jan 05 2018 at 10:37):ok, i will try
Jeff Sieu (Jan 05 2018 at 10:37):then oed / <some primitive is in the model>
Jeff Sieu (Jan 05 2018 at 10:37):and thereby translate the whole model
Rahil Malik (Jan 05 2018 at 10:38):actually i even tried the adc xyz 0 0 0, but it didn't work
Rahil Malik (Jan 05 2018 at 10:38):OK, i will try that right away
Jeff Sieu (Jan 05 2018 at 10:38):And I believe that the bounding box of the model can be obtained, so you can use that then translate <x> <y> <z>
Rahil Malik (Jan 06 2018 at 00:03):I tried using the center 0 0 0 command , the object did go to a new place but when i blast the object again, it respawns right back where it was, what should i do ?
Rahil Malik (Jan 06 2018 at 00:35):I used your and @Sean 's suggestion and i translated my whole combination using tra command in the mged command line
Thank You!! :))
Last updated: Jan 09 2025 at 00:46 UTC