PIXBLEND(1)
DESCRIPTION
pixblend, given two streams of data, typically pix(5) or bw(5) images, generates a "blended" output stream of the same size. This routine operates on a pixel-by-pixel basis, and thus is independent of the resolution of the image. The type of blending performed is determined by the following options:
OPTIONS
- -r VALUE
-
This specifies random blending; for each pixel of the output stream, a number will be chosen uniformly from the interval [0, 1]. If this number exceeds VALUE, then the pixel from the first image will be output; otherwise, the pixel from the second image will be output. Note that if VALUE is 0, then the output will equal the first image; if VALUE is 1, then the output will equal the second image.
- -i VALUE
-
This specifies linear interpolation; for each pixel of the output stream, the interpolated pixel ((1.0 - VALUE) * pixel1
VALUE * pixel2) will be output (where pixel1 and pixel2 are the corresponding pixels from file1 and file2, respectively). Note that if VALUE is 0, then the output will equal the first image; if VALUE is 1, then the output will equal the second image. - -s SEEDVAL
-
Sets the random number seed to SEEDVAL (default is 0).
- -S
-
Instructs pixblend to use bits from the clock as a random number seed.
- -g GVALUE
-
Tells pixblend to "glitterize" the image; if the random draw for a pixel is below GVALUE, then the pixel output is white; otherwise, the pixel used is determined by the ratio set with the -r option (see above).
EXAMPLES
pixblend -i .25 source.pix destination.pix > out.pix pixblend -r .75 source.pix destination.pix > out.pix pixblend -r .5 -s source.pix destination.pix > out.pix pixblend -r .5 -s 23 source.pix destination.pix > out.pix
COPYRIGHT
This software is Copyright (c) 1989-2021 by the United States Government as represented by U.S. Army Research Laboratory.
BUG REPORTS
Reports of bugs or problems should be submitted via electronic mail to devs@brlcad.org